Categories

Manufacturers

Newsletter

  •  

Arduino Mega ADK (Android Compatible)

The Arduino ADK is a microcontroller board based on the ATmega2560. It has a USB host interface to connect with Android based phones. It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button.

More details


57,95 € tax incl.

AC-AR-A000063

Introduction
The Arduino ADK is a microcontroller board based on the ATmega2560 (datasheet). It has a USB host interface to connect with Android based phones.It is compatible with Android's Accessory Development Kit examples. It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button.
The ADK is based on the Mega 2560.
Similar to the Mega 2560 and Uno, it features an Atmega8U2 programmed as a USB-to-serial converter.
The Android 3.1 platform (also backported to Android 2.3.4) introduces Android Open Accessory support, which allows external USB hardware (an Android USB accessory) to interact with an Android-powered device in a special “accessory” mode. When an Android-powered powered device is in accessory mode, the connected accessory acts as the USB host (powers the bus and enumerates devices) and the Android-powered device acts as the USB device.
Specification
  • Microcontroller:ATmega2560
  • Operating Voltage:5V
  • Input Voltage (recommended):7-12V
  • Input Voltage (limits):6-20V
  • Digital I/O Pins:54 (of which 14 provide PWM output)
  • Analog Input Pins:16
  • DC Current per I/O Pin:40 mA
  • DC Current for 3.3V Pin:50 mA
  • Flash Memory256 KB of which 8 KB used by bootloader
  • SRAM:8 KB
  • EEPROM:4 KB
  • Clock Speed:16 MHz

Documents

Cart  

No products

Shipping 0,00 €
Total 0,00 €

Cart Check out

New products

No new products at this time