MiFare Classic (13.56 MHz RFID/NFC) Bracelet - 1KB
MiFare Classic (13.56 MHz RFID/NFC) Bracelet - 1KB
Catégories
- Domotique
- Robots Jouets
- Robots Hobby
- UAVs et Drones
- Robots Pros
-
Robotique
- Arduino
- Microcontrôleurs
- Outils de développement
- Programmateurs
- Shields
- Capteurs
- Sans-fil
- Afficheurs LCD/OLED
- LilyPad
- Contrôleurs de Moteurs
- Moteurs & Réducteurs
- Servomoteurs
- Alimentations & Régulateurs
- Roues & Chenilles
- Bras
- Interfaces
- Breakout Boards
- Prototypage
- Reconnaissance vocale
- Accessoires
- Quincaillerie
- Electronique
- Kits
- Outillage
Newsletter
Les clients qui ont acheté ce produit ont également acheté...
This is a blank MiFare Classic silicone bracelet - often used for parties/events or identification but also found in other systems where a small proximity card is desired. The bracelet contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away
These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino !
These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.
These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino !
These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.
S50 chip specification:
- 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
- Built in encryption engine with 48-bit key
- 4 Byte unique identifier burned into the chip
- 13.56 MHz frequency
- Fits wrists/ankles/hands up to 70mm (2.75") diameter 25.4mm diameter
- Bracelet made of rugged waterproof silicone
- 0.9 grams / 0.03 oz
- Works about 1" away from reader
- Weight: 14.86g
Panier
article
(vide)
Nouveaux produits
Aucun nouveau produit à l'heure actuelle